Asus aura catastrophic failure12/3/2023 If you have (ar buy additional) other case fans, they can be connected similarly, perhaps using fan and lighting Splitters. 38) an Addressable RGB (ARGB) system (3-pin connector with 5 VDC power) can connect to the JRAINBOW header (p. Plain RGB (4-pin connector with 12 VDC power) lights can connect to the JRGB1 header (p. If you get one with lights in its frame (will have TWO cables from it), there are two different possible systems, and your mobo has one lighting header for each of these two. It can plug into one of your mobo's two SYS_FAN headers (see your manual, p. For that you should aim for a 4-pin 120 mm size. Your better option may be to buy a standard case fan and replace the failed rear fan. That puts us at option (a) which is not working, so we get to (c) fan failure.In that case, getting a replacement from the makers may not be possible. If those things are NOT fan control buttons, then there may be none. Those MAY be drawings of fan blades, so MAYBE those are the controls for turning the fan on or off, and MAYBE for fan speed. Then there are two smaller buttons with symbols. That one should do something to control the lighting display. At left is the large Power button, and next a smaller round button with a label that says "LED", I think. But the photos show the buttons on the top front. I found no info on this from the case web page. (b) the fan action (and maybe speed) is controlled by some case button you have not used yet or, (a) the fan always has power and should run at all times at a fixed speed So the motor MUST be designed to receive power from the only source - the module in the case front where that able plugs in. Does that case have NO other ventilation fans?Īpparently there is only ONE cable to supply both fan MOTOR and LIGHT power and control to it. By the way, so far your description talks only about ONE pre-installed case fan. And unfortunately that also means it would be hard to test the fan motor since we don't know the pin use details. From your description the connector is NOT any common standard, so I am not surprised that the fan did not work when plugged into a mobo fan header. BUT we are dealing here with only one fan, and it is not turning. That is a daisy-chain arrangement so you could plug in a second fan to the male output. So your fan has ONLY one cable with matching male and female connectors. That post with details of the daisy-chain fan system was NOT from OP, and happens to detail the wrong fans. The most complete currently available is this one, which includes the Aura Cleaner tool and multiple versions of Aura Sync.Sorry, I missed an important point. There are users sharing older versions in Google Drive. For others, that is not available anymore, and old links just give a 404. (*) It seems for some devices, Asus Support still keeps older versions of Aura specific for that device (hidden after a "show all"). If it crashes, start again trying another version. If there is a subfolder "LightingService", get in and install first "AuraServiceSetup.exe".
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |